Article List

• High performance and Low Cost Engineering Plastics Modification

  Engineering plastics can be modified by physical, chemical or physical and chemical methods, including blending (alloying), copolymerization (grafting) and filling reinforcement.

  Material Introduction December 12, 2018
• Examples of Toughening Modification Formula

  Examples of toughening modification formula.

  Material Introduction December 10, 2018
• Toughening System of PP

  PP/PE toughening system The toughening effect of LDPE on PP is obvious, but other mechanical properties such as flexural modulus decrease rapidly. When the content of HDPE in PP is less than 10%, it has a rigid toughening effect on PP, that is, while increasing the impact property, other mechanical

  Material Introduction December 07, 2018
• Design Examples of Inorganic Rigid Particles Toughening Formula

  Design Examples of Inorganic Rigid Particles Toughening Formula : PP + calcium carbonate/ kaolin/ Precipitation BaSO4/ Nanofiller/ Alkali earth metal salt.

  Material Introduction December 05, 2018
• Matters Needing Attention in the Design of Toughening Formula

  Matters needing attention in the design of toughening formula: 1.The compatibility between elastomer and resin should be good. 2. Compatibilizer 3. Synergistic effect of elastomer 4. Other factors to be considered 5. Rigidity compensation

  Material Introduction December 04, 2018
• Antistatic Technology of Polypropylene Materials

  antistatic automotive PP materials have become one of the important directions in the field of plastic modification.

  Material Introduction November 30, 2018
• PVC/TPU Blending Modification

  PVC/TPU Blending Modification

  Material Introduction November 28, 2018
• PVC/ABS Blending Modification

  The blend of PVC and ABS can combine the advantages of the two and become a new type of material with wide application in electric housing, electrical components, automobile dashboard, textile equipment, luggage and so on.

  Material Introduction November 26, 2018
• PVC/EVA Blending Modification

  Rigid PVC/EVA blends can be used to produce plates and profiles, or to produce low-foamed products. Soft PVC/EVA blends can be used in the production of cold resistant film, sheet, artificial leather, and also used in the production of foaming products.

  Material Introduction November 21, 2018
• PVC/MBS Blending Modification

  Improve the impact strength of PVC and the processability of PVC. Widely used in toughening and modification of rigid PVC, especially in transparent products.

  Material Introduction November 19, 2018